The machine has a 5C draw bar and is as smooth as a HLVH lathe. The ways are in very good condition and are uniform through the entire travel on both axes and the knee, no tight or loose areas. Power feed on all X, Y and Z axes. This is swurely a collectors dream! The item “HARDINGE MODEL MV VERTICAL MILLING MACHINE, 5C (THE WAYS ARE AS SMOOTH AS SILK)” is in sale since Wednesday, October 14, 2015. This item is in the category “Business & Industrial\Manufacturing & Metalworking\Metalworking Tooling\Equipment Specific Tooling\Milling”. The seller is “offerandown” and is located in Berkeley, California. This item can’t be shipped, the buyer must pick up the item.

BRIDGEPORT Knee Type Vertical Milling Machine Used AM14226. Table: 9: x 42. Power Feed on Table Left & Right. Anilam Mini-Wizard Digital Read-Out. Installation / Maintenance / Operation Manual. 480 Volt, 60 Hz, 3 Phase Electrics. Dust ExtractionFabricating MachinerySawing & CutoffTube & Pipe. This item is on our floor available immediately, subject to prior sale. Do not hesitate to call with any further questions and we look forward to doing business with you. And this sale of these items is on an as-is and without any representations or. Warranties, expressed or implied, of any kind including safety, condition, or quality. Protection of the user or to comply with applicable governmental laws or requirements. And understood that purchaser assumes this responsibility and the above is an integral part of this sale. All sales are F. Cleveland, Ohio unless otherwise specified. The item “Bridgeport Vertical Milling Machine 9 x 42 2-HP Series 1 Used AM14226″ is in sale since Wednesday, October 14, 2015. This item is in the category “Business & Industrial\Manufacturing & Metalworking\Metalworking Tooling\Equipment Specific Tooling\Milling”. The seller is “allsetmachine” and is located in Cleveland, Ohio. This item can be shipped to United States.

• Brand: Bridgeport

Here’s a rare Hamilton Associates Vertical Milling Machine. These were made in Baltimore MD in the 1960′s and 1970′s. Hamilton marketed these primarily to schools, and as such, few survive today and virtually none in this condition. Machine operates perfectly and is 99% original. The knob that locks the countershaft was replaced as the old plastic one had deteriorated beyond repair. Wiring has been checked and is all in good condition. The pinion gear that operates the quill down feed has some minor damage because it had been loose. It has been tightened and re-adjusted and it operates fine. This machine has been completely disassembled with the exception of the spindle. Everything has been cleaned and inspected, re-lubricated and reassembled and adjusted. Just plug it in and start making chips. Machine is 24″ tall, 21″ deep. Table is 2-3/4 x 14 Total weight is approx. Motor is the original 1/3 HP Westinghouse. Takes inexpensive and easy to find #1 Morse Taper collets and tooling. Comes with a 1MT Shell Mill holder and some Brown & Sharpe cutters. Even has the original vise. See my other listings for a matching Hamilton Horizontal Milling Machine. I also have a Hamilton 6 Metal Lathe that will be listed as soon as some minor repairs have been completed. It will need to be partially disassembled for safe packing. The item “Hamilton Associates Benchtop Vertical Milling Machine Made in USA” is in sale since Wednesday, October 14, 2015. This item is in the category “Business & Industrial\Manufacturing & Metalworking\Metalworking Tooling\Equipment Specific Tooling\Milling”. The seller is “rapple1066″ and is located in Monroe, New York. This item can be shipped to United States.

• Brand: Hamilton Associates
• Model: Vertical Miller

Recent searches

• Benchtop mill 1970