All products are as is. VERTICAL TABLE TRAVEL: 16. HEAD TILT: 90 DEG. DISTANCE SPINDLE TO COLUMN: 21. LONGITUDINAL TABLE TRAVEL: 28.
Comments Off
Power Drawbars to fit Southwestern Industries Prototrak Bed Mills. Overall length 25.150″ 5/8 -11″ thread. Fits older model DPM, TRM, and B3 bed mills.
Comments Off
Table power feed units reduce operator fatigue. Not What You Were Looking For? .
Comments Off
1 x Power Feed Z-axis for Milling Machine. Max Torque: 450 in-lb. Max Feed Rate: 650 mm/min. Rotate Speed: 0-200 RPM. 1 x Copper Gear & 1 x Flat Key Pin. 2 x Limit Switch Spring+1 x Handle Spring. 1 x Connecting Rod & 1 x Flange.
Comments Off
Power Drawbars to fit Southwestern Industries K2, K3 Knee mills with R-8 spindles.
Comments Off
1 x Power Feed Z-axis for Milling Machine. Max Torque: 450 in-lb. Max Feed Rate: 650 mm/min. Rotate Speed: 0-200 RPM. 1 x Copper Gear & 1 x Flat Key Pin. 2 x Limit Switch Spring+1 x Handle Spring. 1 x Connecting Rod & 1 x Flange.
Comments Off
Applicable models: horizontal turret milling machines, drilling and milling machine, other machinery. Model: ALB-310SX (Horizontal). Our product is the default US plug. Main motor power: 95w.
Comments Off
1 x Power Feed Z-axis for Milling Machine. Max Torque: 450 in-lb. Rotate Speed: 0-200 RPM. 1 x Copper Gear & 1 x Flat Key Pin. Max Feed Rate: 650 mm/min. 1 x Connecting Rod & 1 x Flange. 2 x Limit Block.
Comments Off
Use one hand to hold the center transmission shaft. Set the bevel gear on axis screw with the other hand. Then check if the backlash between gears is between 0.1-0.2mm. Tighten the handle to start setting socket parallel key and bevel gear.
Comments Off
Type: Vertical Milling Machine. Nice machine ready to go back into service. Lots of extras with this mill. You can inspect in person or watch the video.
Comments Off
