US Nema23 stepper motor 435oz+driver DQ542MA 18-50V+Power supply350w 36v

4PCS stepper motor drivers DQ542MA 4.2A 50VDC 125Microsteps. 2PCS power supply 350W 36V. 3.0Nm(425oz. In). Stepper Motor Driver DQ542MA. DQ542MA is a type of two-phase hybrid stepping motor driver, The drive voltage of which is from 18VDC to 50VDC. It is designed for use with 2-phase hybrid stepper motor of all kinds with 42mm to 86mm outside diameter and less than 4.0A phase current. This circuit that it adopts is similar to the circuit of servo control which enables the motor run smoothly almost without noise and vibration. Holding torque when DQ542MA runs under high speed, is also significantly higher than the other two-phase driver, whats more. The positioning accuracy is also higher. It is widely used in middle and big size numerical control devices such as curving machine. CNC machine, Computer embroider machine, packing machines and so on. High performance, low price. Average current control, 2-phase sinusoidal output current drive. Supply voltage from 18VDC to 50VDC. Overvoltage, under voltage, overcurrent, phase short circuit protection. 15 channels subdivision and automatic idle-current reduction. 8 channels output phase current setting. Offline command input terminal. Motor torque is related to speed, but not related to step/revolution. High holding torque under high speed. Not condensation, no water droplets. Prohibition of combustible gases and conductive dust. POWER SUPPLY 350W 36V. 350W Single Output Switching Power Supply. AC input range selected by switch. Protections:short circuit/overload/over voltage/over temperature. 100% full load burn-in test. Low cost, high reliability. AC input voltage range: 90. AC inrush current: cold start 25A/115V, 50A/230V. DC adjustment range:±10% rated output voltage. 135%, hiccup mode, auto recovery. Setup, rise, hold up time: 200ms, 50ms, 20ms/230VAC at full load. Working temperature and humidity:-10. Set pins according to software as follows. Output pin: P1, P2, P3, P4, P5, P6, P7, P8, P9, P14, P16, P17. P2 X axis Pulse, P3 X axis Direction. P4 Y axis Pulse, P5 – Y axis Direction. P6 Z axis Pulse, P7 Z axis Direction. P8 – A axis Pulse, P9 – A axis Direction. P14 – B axis Pulse, P1- B axis Direction. P16 – C axis Pulse, P17- C axis Direction. Input pin: P10 , P11, P12, P13, P15. Set them for Emergency Stop and X Y Z Limit switch. The item “US Nema23 stepper motor 435oz+driver DQ542MA 18-50V+Power supply350w 36v” is in sale since Monday, July 27, 2020. This item is in the category “Business & Industrial\CNC, Metalworking & Manufacturing\Metalworking Equipment\Machining Centers & Milling Machines”. The seller is “cncmotor111″ and is located in Rowland Heights, California. This item can be shipped worldwide.

• Machine Type: Milling Machine
• Power Source: Electric
• MPN: Does Not Apply
• Function: Drilling
• Brand: wantai
• Control: Automatic
• Voltage: 36v/48VDC