90°BT40/50 Angle Head Side Milling Head Cross Milling Head Right Angle Head1-7mm

Precautions for using angle milling head 1. Check whether the weight of the angle milling head meets the weight requirement of the machine tool magazine. (If not, it is recommended to install the angle milling head manually) 2. Check whether the fastening bolts are loose before the angular milling head is installed and processed. Check whether the positioning pin of the angle milling head is fastened with the groove of the fixing block. Check whether the limit pin is completely detached from the positioning ring before use. Do not use the angle milling head continuously for a long time. It is recommended to stop the machine for 5 minutes after 2 hours of machining to prevent overheating of internal parts such as bearings and gears inside the angle milling head. Use a grease gun to inject a small amount of grease every week to lubricate the gears. Do not use the angle milling head when you need to do a good anti-corrosion treatment. Strictly prohibit the use of angle milling head more than the maximum speed range of speed, general use of the maximum speed of 70% of the maximum speed, can be used for a short period of time the highest speed. It is strictly prohibited to strike the angle milling head shell vigorously to prevent the internal bearing gears and other parts from being broken. Keep the input shank and output taper clean when using the angle milling head. Before installing a cushion at the bottom to prevent the angle milling head from dropping the american mushrooms name countenance legs sticky calabash amber tailored like a person.